7.6 Optical Path Adjustment

If the workpiece cannot be cut through by the preset parameters or the power output seems to vary a lot on each corner of the working area, the optical path might have got misaligned and need to readjust. Try the steps below.

Tools

mceclip0.png
Accesory Box:
② little wrench
④ double-sided tape
Prepare On Your Own:
① 2.5mm Allen key


1. When pressing "Laser Pulse", please keep the door shut so the laser will not be disabled by the
door interlock protection.
2. If you hear a loud cracking sound, stop operating and shut down the power immediately. Contact
FLUX Support.
3. Remove the screw on the handle of the back lid and open the lid to access the laser tube.


There are three sets of reflecting mirrors and one set of focusing lens in Beambox.

The first reflecting mirror is located on the left side of the laser tube when facing the front of the machine.
The second reflecting mirror is located on the carriage of the guiding rod on the left side when facing the front of the machine.
The third reflecting mirror is located on the rail of the X-axis.
The focusing lens are located inside the lens holder beneath the third mirror.

mceclip1.png

Have more questions? Submit a request